CHRYSLER Diagnostic Software for X-431 Series V29.40
Compared with the previous version:
updates as following:
1). Added the following special functions for the RFH system of car models after 2011: RF-HUB Replace, Erase Ignition FOBIKs, ELV Replace Disable Key-Alike Program Ignition FOBIKs, Clear Multi-Module VIN Handshake Immobilizer Failure, View Recent Multi-Module VIN Handshake Immobilizer Failures, ESCL Replaced , BCM Replaced, Remote Start Antenna Test, View Ignition (IGNM/KIN) Part Information, update Front and Rear Axle Nominal Tire Pressure Values
System test functions: TPM Sensor Rolls Test, Locate Learned Keys, Door Handle Verification Test, Immobilizer Antenna Test, LF Antenna Verification Test, Read Ignition Module (IGNM) Software Information
2). Added the following system test functions for the IPC, TGW, and RADIO systems of car models after 2005: IPC Self Test, Radio Tone Test, Radio Anti Theft Override Test, Radio Hard-drive Back-up, TGW Anti Theft Override Test
3). Added the following special functions for the HCP system of 2009 HB and HG car models: Check VIN, Enable Jump Assist Mode, High Voltage Battery Charge, Hybrid Trans Start/Stop, Regulation of Low Voltage Control, Replace HCP, Reset High Voltage Impact Event, Shift Lever Position Test, Trans Aux Pump Speed, Transmission Motor Control, View Battery Pack Information, View ESMR Battery Usage History, View HV Charge Mode Status and Amp Hours of Algorithm Charge, View Hybrid Commanded Engine Status, View Strong Hybrid Limp In Status, Regen Brake Control, High Voltage Battery Pack Under Voltage Recovery System test functions: Shift Lever Position Test, Constrain Battery Power Limits, High Voltage Contactor Circuit
4). Added the following special function for the HGM system of 2009-2011 HB, HG, DS: TPIM Cooling Fan Actuation
Added the following special function for the MCPA and MCPB systems of 2011 DS and RT: Resolver Offset Learn Trigger Test
5). Added the special function Initialize ABS Module for the ABS system of car models after 2005. Added the special function Set Sync Signal for the Engine system of car models before 2002.
6). Added basic functions and Actuation Test for 24 modes of the PCM, ABS, BCM, TTM, TPM, TCM, RADIO, ORC, IPC, HVAC, ETM systems.
7). Added the following system test functions for the Engine system of car models after 2007: Generator Full Field Test, Injector Kill System Test, Fuel Pressure Override, Set RPM System Test, High Pressure Fuel System Test, Fuel System Run Up Test, P2262 Fault Diagnosis Test (Before Repair)
8). Added the following special functions for the ORC system of car models after 2008 and the PLGM system of car models after 2006: Initialize ORC, Ramp Van Configuration, Calibrate Liftgate Full Close Position, Calibrate Liftgate Full Open Position System test functions: Latch Home Sector Test, Activate Driver and Passenger Head Restraint
9). Added special functions and system test functions for the OHC, SKM, MIC, MVAC, DDM, LPSDM, PLGM, RPSDM, XCM, TCM, ABS, BCM systems of VPW-protocol car models before 2005. Added the following system test functions for the CCD-protocol TCM system: Shift Lever, Clutch Test, TRD Link
10). Added the following special functions for the ASCM, DTCM, AMP, ABS, TPM, FFCM, FFCM, PTS, OCM, HVAC, CCN, ORC, ACC, BCM systems of car models after 2011: Read Digital Encoder Channels, Auto Door Lock, Auto Door Unlock, Seatbelt Alert Minder, Unlock Driver Door On 1st Press, Change Language Preference, update Measurement Unit System test functions: Self Test, System Wiring Test
11). Optimized special functions for the ABS and WCM systems of car models after 2005.
12). Optimized the DTC function for the Engine system of car models before 2002.
13). Optimized the actuation test button.
14). Optimized the history diagnosis function.
X-431 V、X-431 V+、Diagun III、X431 Pad、Matco PAD、X431 PAD II、X431 Pro、X431 PRO3、X431 iDiag、EasyDiag、ScanPad071、ScanPad101、MaxGo、Maximus2.0、golo、CRP_HD、X431_HD、X431-Diagun、X431-Master/GX3、X431-Tool、X431-AutoBook